Installing the Carqon Maxi Cosi Carrier
Strong Carqon Maxi-Cosi carrier to transport your baby safely. The carrier is securely mounted on the frame with hangers that, together with the suspension fork, creates great driving comfort.
Step 1: guide the brackets securely into the slits of the metal plates with black caps by pushing them down firmly and fasten the brackets with the hex key 4. Check carefully if the brackets are firmly secured so they cannot come off. Tighten the M6x30 hex key in such a way that it is even with the black cap.
Note: the bolt should not protrude, but shouldn’t be screwed in too far either.
Step 2: slide both brackets, with the bracket arms pointing out, over the brackets in the box. Fasten both arms in the lowest position possible – but at the same height – to the brackets using two M6 bolts per side.
Note: the height of the carrier can be adjusted 2-3 cm if needed, for leg space at the box bench. The position varies per type of car seat.
Step 3: insert the two Maxi-Cosi adapters into the carrier until you hear a clicking sound. Pay attention to the L (Left) and R (right) on the adapters. Make sure that the adapters are firmly secured.
Step 4: It is possible to remove the adapters by pushing the button and pull it out of the carrier.
Step 5: Check if the carrier is fastened correctly and firmly by pulling and it a couple of times. It is normal that the carrier is moving a little due to the play on the box and the suspension front fork.
Step 6: You can remove the Maxi-Cosi from the Maxi-Cosi carrier by pressing the release buttons on both sides of the Maxi-Cosi, and lifting it up.
For the instruction video see below.